LS3 o2 levels dont show up

[mrgillies]

Hi Y'All

I love your program and I have learned so much, I do have one quirk that I cannot get my head around.

I am monitoring all the recommended parameters but the o2 Sensorr B1S1(V) and B2S1 (V) up as the infamous "No Data" on the WOT Burst(s) Tab

I am recording Oxygen Sensor Bank 1 Sensor 1 (V) and Oxygen Sensor Bank 2 Sensor 1 (V) and have the voltage values listed on the csv file.

On the excel spreadsheet, the top row, there are two colums labeled Oxygen Sensor Bank 2 Sensor 1 and  Oxygen Sensor Bank 1 Sensor 1 with the second row Having a V listed below

I did Export a reduced Data files for WOT and worked an average with my o2 levels of 0.843 and 0.844, these being below the recommended values between 0.88 and 0.98 V

All my other results indicate that I am correctly addjusted for AFR Min 12.23 Max 14.75 LTFB indicate need no adjustment but there is some knock,  Total knock is 9.844 deg with a Knock retard of 5.977 deg

I am just wondering if o2 not being dialed in mamay require some more adjustment

Many thanks

Steve

[06MonteSS]

there's no need to log/monitor the O2 sensors man...

all you need to log is:

air fuel ratio
commanded throttle position
engine speed
intake air temp
long term fuel trim bank 1
long term fuel trim bank 2
MAF Sensor Mass Airflow
spark advance
total knock spark retard

[mrgillies]

Thanks, just making sure I'm not doing anything wrong, its just seeing "No Data" in the o2 part made me suspicious.

Planning some more upgrade to exhaust systemand Intake, will be spashing out on the DiabLew tune at that pont

Thanks Again

Steve

[06MonteSS]

Thanks, just making sure I'm not doing anything wrong, its just seeing "No Data" in the o2 part made me suspicious.

Planning some more upgrade to exhaust systemand Intake, will be spashing out on the DiabLew tune at that pont

Thanks Again

Steve

cool man, sounds good...

thanks!!